PDA

View Full Version : Conzult wiring for pre OBD2

jmizell2
03-04-2007, 01:41 PM
Can anyone tell me the correct wires to hook up a conzult connector to a pre obd2 harness (1993)

I am having a spark issue and need to moniter sparks advance a fuel injection while running.
nrg
03-04-2007, 02:11 PM
http://www.plmsdevelopments.com/consult_wiring.htm
g6civcx
03-04-2007, 05:07 PM
Check under the underdash fusebox for the CONSULT connector.
projectRDM
03-04-2007, 05:46 PM
All 91-up cars have a CONSULT plug.
jmizell2
03-04-2007, 09:43 PM
I need to restate my configuration. I have a 1990 nissan 240sx with a 98 engine. I used a 93 engine harness plus ecu and distributor to make it all work together. I do not have a conzult plug but think that one can be wired into the harness if I knew which wires to access.

Thanks for all the replies so far.

John
projectRDM
03-05-2007, 12:05 AM
FSM.

There's a total of five wires, three from the ECU, ground, and ignition. Very, very simple.
jmizell2
03-05-2007, 06:37 PM
does it require a special cable to access the ecu.
codyace
03-05-2007, 06:48 PM
does it require a special cable to access the ecu.

IN order to read from the consult port, you will need some sort of cable and a device (N Probe/Conzult/CalumSult) to read it...


When I swapped my Redtop in my 97, the consult wasn't wired into the conversion harness...I actually wired the port in it direct, and put the connector on the passenger side, as I knew it would make it easier than having to tangle the cord all over the driver when reading from it :D