N60

[OBEEWON]

http://photos-052.ak.facebook.com/ip002/v64/159/31/60715691/n60715691_31082052_8801.jpg

OK. These are the wires I have on my connector for my N60 MAFS. Ive looked at probably every writeup for the install, but none of them correspond to the colors seen above. I have two black wires with red dots, a cream colored wire, a silver wire and a white wire both with red dots. I really want to make sure everything is connected properly so I don't fry anything. All the writeups show pictures with connectors that have only 4 wires.

Thanks in advance.

[projectRDM]

Page is down.

It's the exact same pinout as the N62 MAF.

[OBEEWON]

Can you give me the pinout you have? When you are doing the pinout how do you orient the connector? Which side is concidered the top?

[S14DB]

It's the same as the 300zx (N62) maf.

[OBEEWON]

So I dont use the two wires on the far ends of the connectors and
white wire goes to = white
Black = ground to chassis
Black = harness ground
white with red dots goes to = black/ white Power?

Is this correct? Or am I assigning the pin in reverse order?

[Wei240]

don't remember, but i do remember searching and it's relatively easy/straight forward

i hope in closer inspection of your maf, there are numbers going left to right or maybe alphabets (it's weird, why can't they use just one standard...), but if memory serves me correctly, you don't use the 2 outter piece...

sorry for the nonsensical babble, but i'd search again, it's been covered quite a few times

[OBEEWON]

Thanks for the help but I've been searching all day...literally...on every forum.

[drift freaq]

All you have to do is go by the ABCDE lineup or the 123456 lineup. Anyways if you line it up like the N62 Maf and follow the wiring info for the N62 Maf it all corresponds. Now if you still don't understand, there is and arrow on your maf that indicates the engine side. Now you can either use the numeric count or the ABCDEF count. The A or 1 starts on that side, some mafs have numeric some have letter but the pin out info is the same for the two. follow the pinout info you would follow for the n62 maf wiring to the letter and you will nail it. Its logical and simple just go by the instructions I gave.