PDA

View Full Version : KA-T setup: Greddy, Turbonetics, TiAl, Clutch to injectors!


napoleon
01-29-2007, 09:49 AM
This kit was Chris May's killer set up that was featured in SCC back in like 2001. The turbo I am using is NOT what he used and the oil lines and humphoses are new and i dont have the turbo inlet pipe for the filter, since i am using a Z32 MAF.I have to buy a new DD and the more money i have, the nicer the one i can get. This kit is everythin from injecors, to turbo, to intercooler to clutch.
SoI am pricing out this KILLER setup. This is for an S13/14
Turbonetics T04B H-Trim Fresh rebuild, never been run
JGY oil line kit with oil pan and bung welded in!
XS Engineering IC Core
Custom intake mannifold(all EGR and emmissions ports cut off, welded shut and machined, super pimp!)
custom log style manifold(identicle to RH)
Custom 2.5'' IC pipes, powdercoated Gloss black
Custom 3'' downpipe with 5 bolt flange, 02 bungs and WG recirc
Nice Silicone humphoses and reducers and T-bolt clamps
Greddy Type RS BOV-slightly used
JGY top feed fuel rail BN
450cc high impedance injectors with pigtails BN
Z32 MAF and pigtail
TiAL 38mmWG with 10psi spring
DNA Manual Boost controller BN
Powercaoted valvecover included.
SPEC Stage 3 Clutch, still in package!
http://www.hsvracing.com/phpBB2/files/ka_t2_142.jpg
http://www.hsvracing.com/phpBB2/files/ka_t1_369.jpg
http://www.hsvracing.com/phpBB2/files/wmold_turbo_i_764.jpg
I WILL NOT Part out. I would like 3500 shipped to your door. Offers are accepted, but low balls will be ignored. This is THE kit if you want serious HP.

napoleon
01-29-2007, 10:44 AM
also, will throw in dual 91 exhaust cams, and cometic MLS HG

codyace
01-29-2007, 04:03 PM
What engine managment is it using/is it included?

napoleon
01-29-2007, 05:31 PM
none. i hadnt made my mind up, whch is prob a good thing for potential buyers to use what they want.

napoleon
01-30-2007, 08:24 AM
sure is a nice kit

s13gold
01-30-2007, 09:19 PM
:bigok: can i get pix of the manifold?

napoleon
01-31-2007, 09:29 AM
PM sent. I dont have any more pics other than the ones you see here. The manifold was built by a fabricator at Lockheed-Martin.

napoleon
02-01-2007, 11:37 AM
william shatner

napoleon
02-02-2007, 08:55 AM
any offers? lol...

clutch kick drifter
02-11-2007, 07:03 PM
its a TYpe S bov, Bump for you though for a clean ass car! ( could you send me some pictures of the welds on the bov flange up close please) !