FCsilvia
11-20-2006, 05:35 PM
I have a near new Haltech E6X. The Haltech ECU was installed in my car for about 4 months. The harness was replaced with a brand new flying lead purchased from SpeedMachinePerformance about 2 months ago. The car started up, but I never took the car out of the garage. Now the go is undergoing a whole new setup and new engine management system.
So here's the deal.
- Haltech ECU E6X
- Brand New flying lead harness with fuse block
Already completely braided, expanding loomed, heatshrinked, and a section above the turbo area has heat-resistant loom.
- Includes sensors: water temp sensor, air temp sensor, and 3 map sensors (2 3bar and 1 1bar)
http://i12.photobucket.com/albums/a244/Chirhofelix/Parts/IMG_0707.jpg
I'm just looking to recooperate some of my losses.
Asking $850 obo for everything.
So here's the deal.
- Haltech ECU E6X
- Brand New flying lead harness with fuse block
Already completely braided, expanding loomed, heatshrinked, and a section above the turbo area has heat-resistant loom.
- Includes sensors: water temp sensor, air temp sensor, and 3 map sensors (2 3bar and 1 1bar)
http://i12.photobucket.com/albums/a244/Chirhofelix/Parts/IMG_0707.jpg
I'm just looking to recooperate some of my losses.
Asking $850 obo for everything.