PDA

View Full Version : USDM 97 S14 to JDM Bumper Conversion, Energy Absorber Replacement?


S14_306
11-08-2006, 07:49 PM
Hi, I was just wondering if you were to swap the usdm front bumper to the JDM front bumper, do you replace the energy absorber? or does the usdm one fit just as good? Thanks.

TurK
11-08-2006, 08:42 PM
it pretty sure that it fits just fine....only thing i see you having to do is trim it if you have a frontmount.

chmercer
11-08-2006, 08:46 PM
place styrofoam piece in trash can

install bumper

operation complete

projectRDM
11-08-2006, 11:05 PM
^ +1.


fucking message length

chmercer
11-08-2006, 11:26 PM
wait, were you talking about the actual metal crash beam? that would be slightly less retarded of a question

fliprayzin240sx
11-09-2006, 10:50 AM
If you are asking about the bumper reinforment itself, you will have to trim it or take off all together to fit the JDM bumper. The JDM reinforcement is skinnier than the USDM one. WHen I did mine, I got lazy trying to trim it piece by piece and I had a front mount but didnt wanna take it off completely cuz you need something to hold the bumper up in place. So I completely cut the center off to fit my FMIC and trimmed the cornes to fit the bumper. I left the mounting pieces in place to hold my bumper up and left the thin black metal strip on top of the reinforment to bolt the bumper back up in place.

TiNMAN
11-09-2006, 12:02 PM
i just slapped that thing on. no trimming no nothing. just got rid of the styrofoam.

SimpleS14
11-09-2006, 08:02 PM
i just slapped that thing on. no trimming no nothing. just got rid of the styrofoam.


me too...I never had the foam to begin with, I just put the bumper on. It does seem to require very minimal force to fit with the USDM reinforcement, but it fits regardless.

Siizzzoooo
11-09-2006, 08:56 PM
fuck the reinforcement, ride gangsta