s14 zenki skirt install, how'd you guys mount them to the rear quarter panel/fender?

[Indolent]

car: 95 zenki
install: oem jdm zenki side skirts

i know the front fenders the holes line up
then the bottom of course you gotta drill the holes
but what about the two holes on the rear fender side, obviously they don't line up w/the fenders inner lip

i searched and there's some kind of metal clips or something supposedly that clip on, anyone got anymore info, or how'd you guys mount em'?

[ispypsi]

are you talking about putting kouki (stock usdm style) skirts on a zenki body? or the jdm zenki (flat style) skirts?

i know the kouki skirts use "endcaps" which do line up with the i think only one hole on the forward arch of the rear fender. i'm not sure if the flat style ones use endcaps or not, but if they are true OEM Nissan they should line up with the proper pieces.

Also, i did not know you had to drill the underside for the tab looking things to bolt on. i would figure zenki's at least had some capped holes already there lol.

[Indolent]

car: 95 base model zenki
no premade/drilled holes here

installing: oem jdm zenki skirts, no endcaps, i'm assuming there's some type of bracket/clip or something

yeah, they line up perfectly, it's just the 2 holes in the rear don't lay over the inner fender lip, so i'm just wonderin how some people mount them

[ispypsi]

dang. i cant help much on that. if they line up "over" each other, that's good. i know on mine (stock kouki) the end cap is held on from one of the bottom screws and it 'reaches' up higher to line up over the fender lip and there is those white plastic screw guides that it lies on that does the magic.


they're not on backwards are they :D
if anything you can probalby just zip tie it :P

trying to look for pics but not getting the right angles on ones i see and 3am is starting to get to me lol. best of luck on that.

[ispypsi]

http://www.zilvia.net/f/showthread.php?t=112277&highlight=oem+zenki+sideskirts

booyah. :)

[Slidin240Wayz]

I made brackets for the rear. Little pieces of metal. Drill holes in the chasis, bolt down the brakcet. Line up the rear part of the skirt, drill through the bracket, bolt it down. Use big washers to keep the skirt crack free.

Carlos

[projectRDM]

Carlos said it right. The OE design has a small bracket, just make one out of thin plate steel.