1st gen rx-7 rims [Archive] - Zilvia.net Forums | Nissan 240SX (Silvia) and Z (Fairlady) Car Forum

TRUSE-R

03-13-2006, 02:41 AM

I have a set of enkei mesh 4 lug rims off a 1st gen rx-7 ('83). The bolt pattern is very similar to the 240s (wide 4), but the holes on the rim need to be slightly widened in order to mount them. I was wondering if anyone has widened holes on rims in order for them to fit? Does anyone have suggestions? Any and all help will be greatly appreciated.
Thanks,
KEN

TRUSE-R

03-13-2006, 05:52 AM

Admin. I hit refresh and it posted twice. I was wondering if I should have posted this in the tech section?

neverlift

03-13-2006, 06:59 AM

try one size drill bit bigger or better yet take it to a wheel shop,maybe a machine shop, good luck

Gearhead_42

03-13-2006, 07:21 AM

Don't do it! The 1st gen rx7 is a 4x110 pattern, not a 4x114. Far harder to find than even the s13 pattern. You could easily find someone to take those off your hands in trade. In fact, what size are they? I've got a set of s13 teardrops in very nice condition I don't need. And I have an Rx7 :coold:

projectRDM

03-13-2006, 10:06 AM

Offset is too high as well I believe.