Fender Pulling and Rolling in SD?

[LukeDogg316]

Anybody know of a good place to go, that does a decent job fro fairly cheap?

[midnite_180]

i have a fender roller and am willing to help out.

[LukeDogg316]

how good will it look, I am thinking about getting 17x9 rims with 225 40 R17 tires but I know they will stick out about an inch and rub the fenders, I am just curious good will it look. No camber mods though

[midnite_180]

ITS all about the offsets, gotta know the offset, my friend is running a 17x9 with a 225/50 and the offset is poor so he did not need to roll the fender. id say if the offset is less than +18 or so you might have to roll it with that big of a tire. but im not 100% sure.

[sdtouge]

225 40 R17 tires


when did they start making 225 45 17?

luke, as of right now your car is so damn high you could run 17x10-50 with no clearnance problems.

luke, getting an alignment with more camber isnt a camber mod.

your still a poser.... lol.

[gotta240]

To MIDNIGHT 180-

I know this is an older thread.

Would you be willing to rent it out for a day if i payed?

please let me know, as i need to take my car to the painter asap. thanks a lot.

MIKE

[randyjordan]

warren at speedalliance does it for 50 bux

[Helghast]

where's that at?

[rainier]

clairemont in san diego.

[Helghast]

fuck thats far.

UGH!

[RightWheelDrive]

Baseball bat ftw.:naughtyd:

[Helghast]

yea, to roll.

not to pull.

[RightWheelDrive]

If you just pull up slowly and gradually, you can still get a slight pull going with a bat. I didn't have a bat and used a copper pipe when I did mine. 17x8.5 +9 w/ 225/45 which is the same as 17x9 +15. I have the tip of a finger gap between the inside of my fender and the outside of my tire. Free=:yum:

[Helghast]

I can't do away with those small pulls..

18x9 +4 18x10+16 225.245/40/18


I need a real puller.

HELP.