nurvcom

ok i went to my first skidpad even with this car 92 240sx vert

upgraded radiator and installed vlsd and coil-overs and oil psi gauge and did fresh oil change car was run good be for the event 15 to 20psi idle and driving about 35 to 40psi and high rev 60 psi plus now after my last run on skidpad everyone told me my car started smoking bad ... but stopped when i left to drive home but PSI on oil still down idle is 9psi and driving was 20psi and high rev was barely 40psi


could anyone tell me what may have happen

__________________
Ripping up the Highway since 03

importdude

any leaks?
mabe the oil broke down since it heated up alot

__________________

built ka-t

nurvcom

no leaks why would my oil psi be so low?

__________________
Ripping up the Highway since 03

Slammed Assassin

Is it comming from the exhaust or engine bay.. Once you start beating your car it takes a toll on your motor and seals start leaking. For example my first event my front/rear main seal started to leak. But I'm still beating on it till now. Lol

__________________

nurvcom

exhaust .....

__________________
Ripping up the Highway since 03

Slammed Assassin

Rings are most likley getting worn out.

__________________

nurvcom

grate i just put this motor in

__________________
Ripping up the Highway since 03

nismoracingsx

gotta pay to play, isn't that what they say? that's why I stuck to being an "enthusiast" after I built my first 240 for race..too much shit breaking-

nurvcom

ya true i just hate pulling motor

__________________
Ripping up the Highway since 03