sleepyS14se

Just curious what you guys do about the bottom mounting insulator when using a walbro FP.

I purchased and installed a GSS341 and i did my research just to confirm my pump was legit and not a fake. Anyway that is all well and good, my pump is legit.

One problem i ran into was the bottom insulator rubber piece does not fit the walbro very well and I ended up cutting a small section of it out and made it fit the best I could but I am not happy with it. Is there a certain insulator that is supposed to be used or are we stuck using the stock one and modifying it.

Notes:
95 s14
gss341 walbro 255
97 01 prelude sock

__________________
95 S14 se RB25DET 348whp

codyace

It doesn't need to be a 100% fit, but it is super tight for sure. You'll be fine.

__________________

Want Air Conditioning in your SR20 Swapped car? Check out www.sr20acbrackets.com for more information!

Quest Alternator Conversions for SR20! Check my Group Buy!

Tired of lousy internal gates? Go external wastegate with one of my manifolds, Check out my group buy

sleepyS14se

I trimmed the bottom mounting pad and I ummm






Zip tied the pump to the bracket.... I didn't know what else to do without having a better fitting insulator. O_o

__________________
95 S14 se RB25DET 348whp