KWASx408

So today I started my 5 lug swap. My 5 lug parts were purchased from a wrecked s14 and everything was unbolted from the knuckle so it came off in one solid piece. I finished the passenger side without any problems. When I started to take apart the driver 5 lug to get the hub, the bearing came out in pieces, so I thought no problem, I can get a new bearing pressed in. Well now I see these hubs have the bearing built into them and I can't figure out what hubs they are. uploadfromtaptalk1370553237506.jpg

Are these stock se hubs or are they aftermarket. All of the after market hubs on frsport and enjuku say you have to provide your own bearing which would be impossible with these since they are built in. Any help is appreciated.
Sent from my SCH-I605 using Tapatalk 2

KWASx408

Here is a front view showing the bearing inside the hub
Sent from my SCH-I605 using Tapatalk 2

Attached Images

uploadfromtaptalk1370553494686.jpg (68.2 KB, 10 views)

zooopreme

The ones you pulled are stock.

No, you cannot replace the bearings for S14 hubs. You may have been looking at rear hubs with no bearings. Enjuku and FRSport sells Ichiba hubs which are conversion hubs, which S14's don't need when going 5 lug.

But you're in luck, FRSport sells OEM hubs. They come with bearings.

KWASx408

The ones I pulled are different from the ones pictured on frsport and enjuku. Stupid question, but is it Ok to run one new one and one old one lol

Sent from my SCH-I605 using Tapatalk 2

240boi115

unless you have a serious OCD for evenly matched stuff and symetry youll be fine

__________________
my 240 broke down..again

zooopreme

The ones you pulled are the SAME.

Is it okay? I'm on the side that says no. Will your wheels still roll? Sure.

How much time do you have until the bad one gives out? Who knows. I know you're too cheap to think about that.

KWASx408

I'm not too cheap, just the money could be put toward other things... I'll price them out. Thanks guys

Sent from my SCH-I605 using Tapatalk 2