Intercooler Piping for KA-T Recommendations - Zilvia.net Forums | Nissan 240SX (Silvia) and Z (Fairlady) Car Forum

johnnysombrero · 11-15-2016, 11:09 AM

Hi All:

I've got an S14 with a Tomei turbo exhaust manifold. It is currently paired with a T28 (SR20) and the associated piping for the inlet and outlet on the turbo.

I'm planning on running it with a SMIC, and have a Greddy Intake and BOV.

What recommendations are out there for the IC piping (specifically hot pipe) and re-routing the BOV? Thanks in advance.

KAT-PWR · 11-15-2016, 11:12 AM

I believe the Greddy intake pipes have a recirc port?

Honestly isis or any eBay pipe kit will probably be fine, it's just aluminum pipe no need to over complicate it

johnnysombrero · 11-15-2016, 11:15 AM

It does, but the question is more packaging related. The hot pipe (even if bunged) doesn't really have a straight shot to the port on the inlet manifold. The previous setup had a PVC hose that was a 180* J with some fishtank hose. I've replaced every part of the previous setup except for the greddy bits.

So, advice on where to place a new bung for a BOV, or what piping magic is required?

11-15-2016, 11:09 AM	#1
johnnysombrero Zilvia Member Join Date: Feb 2012 Location: Alexandria, VA Posts: 261 Trader Rating: (13) Feedback Score: 13 reviews	Intercooler Piping for KA-T Recommendations Hi All: I've got an S14 with a Tomei turbo exhaust manifold. It is currently paired with a T28 (SR20) and the associated piping for the inlet and outlet on the turbo. I'm planning on running it with a SMIC, and have a Greddy Intake and BOV. What recommendations are out there for the IC piping (specifically hot pipe) and re-routing the BOV? Thanks in advance.

11-15-2016, 11:12 AM	#2
KAT-PWR Nissanaholic! Join Date: Dec 2011 Location: US Posts: 2,040 Trader Rating: (11) Rides Gallery: KAT-PWR Feedback Score: 11 reviews	I believe the Greddy intake pipes have a recirc port? Honestly isis or any eBay pipe kit will probably be fine, it's just aluminum pipe no need to over complicate it __________________ MRP Manufacturing

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

11-15-2016, 11:15 AM	#3
johnnysombrero Zilvia Member Join Date: Feb 2012 Location: Alexandria, VA Posts: 261 Trader Rating: (13) Feedback Score: 13 reviews	It does, but the question is more packaging related. The hot pipe (even if bunged) doesn't really have a straight shot to the port on the inlet manifold. The previous setup had a PVC hose that was a 180* J with some fishtank hose. I've replaced every part of the previous setup except for the greddy bits. So, advice on where to place a new bung for a BOV, or what piping magic is required?