Weird Clutch, Throwout bearing problem HELP! - Zilvia.net Forums | Nissan 240SX (Silvia) and Z (Fairlady) Car Forum

xxmarcusrxx · 12-24-2008, 02:30 PM

So I bought an exedy stage 2 clutch kit. Kit # 06953A. I put it in my 97' s14, since then the clutch fork has ben loose on the pressure plate. Like When everythings bolted up, I can move the fork back and forth a little. I didn't think much of it untill I went through 2 slave cylinders, they were over extending and blowing up on me

. It seems like my slave is extending way too far to engage the clutch. Its basically fully engaged after I bleed the clutch, is this normal?. I did get the flywheel resurfaced, Is there such thing and grinding it too low?

FWD LOL · 12-27-2008, 04:43 PM

it is possible to install the throwout bearing backwards-that would require the slave to have to move farther- but it would not last long at all and you would be able to hear it. race clutches will shorten the engagment travel somewhat.

"Its basically fully engaged after I bleed the clutch, is this normal?"
dont understand this.

ThunderbaySr20 · 12-28-2008, 01:46 PM

you should be able to adjust your clutch pedal...

12-24-2008, 02:30 PM	#1
xxmarcusrxx Zilvia Member Join Date: Aug 2006 Location: Indy East-Side Age: 33 Posts: 156 Trader Rating: (2) Feedback Score: 2 reviews	Weird Clutch, Throwout bearing problem HELP! So I bought an exedy stage 2 clutch kit. Kit # 06953A. I put it in my 97' s14, since then the clutch fork has ben loose on the pressure plate. Like When everythings bolted up, I can move the fork back and forth a little. I didn't think much of it untill I went through 2 slave cylinders, they were over extending and blowing up on me . It seems like my slave is extending way too far to engage the clutch. Its basically fully engaged after I bleed the clutch, is this normal?. I did get the flywheel resurfaced, Is there such thing and grinding it too low?

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

12-27-2008, 04:43 PM	#2
FWD LOL Join Date: Dec 2008 Location: columbus oh Age: 32 Posts: 7 Trader Rating: (0) Feedback Score: 0 reviews	it is possible to install the throwout bearing backwards-that would require the slave to have to move farther- but it would not last long at all and you would be able to hear it. race clutches will shorten the engagment travel somewhat. "Its basically fully engaged after I bleed the clutch, is this normal?" dont understand this.

12-28-2008, 01:46 PM	#3
ThunderbaySr20 Join Date: Nov 2008 Location: Ontario Age: 36 Posts: 30 Trader Rating: (0) Feedback Score: 0 reviews	you should be able to adjust your clutch pedal...