|
Home | Rules & Guidelines | Register | Member Rides | FAQ | Members List | Social Groups | Calendar | Mark Forums Read |
S Chassis Technical discussion related to the S Chassis such as the S12, S13, S14, and S15. |
|
Thread Tools | Display Modes |
04-05-2013, 03:50 AM | #1 |
Leaky Injector
Join Date: Aug 2008
Location: salina, ks
Age: 39
Posts: 83
Trader Rating: (5)
Feedback Score: 5 reviews
|
wet plugs, running rich. need another brain, been staring at car too long
Okay here is my issue:
s13 sr20det Car is running rich. soaks spark plugs, car wont start. fuel pressure is at 40lbs (a little low, normally runs 42lbs, but we were trying to lean it out some, just to see if it would help) when I pull plugs, I am getting spark. 740cc injectors don't leak and have a good conical spray pattern temperature is 12 C new o2 sensor new-er temperature gauges tps is reading the correct ohms timing is top dead center, stabbed CAS 3 different times, followed FRsports guide timing reads 0 degrees at IG on/not running, 3 degrees at cranking injectors read 5-7% duty at cranking MAF is reading 450-700 mV at cranking only sensor that i havent checked is knock. recently went from 2.5inch IC pipes to 3inch car started this morning, revved awesome, rough-ish idle now car wont start at all. cranks, but no fire.
__________________
Don't mix booze and car batteries...it gets expensive, quickly. |
Sponsored Links |
04-05-2013, 06:58 AM | #2 |
Post Whore!
|
Do you have a tune to run those 750's?
__________________
My SR20VET |
04-05-2013, 12:49 PM | #4 | |
Post Whore!
Join Date: May 2009
Location: Bay Area CA, Sutherlin OR
Age: 33
Posts: 3,289
Trader Rating: (3)
Feedback Score: 3 reviews
|
What kind of mods do you have to support those injectors? You still can't just slap them on a stock SR and expect a tune to keep them in check. Just for the hell of it try smaller injectors and see if your problem is alleviated some.
__________________
Quote:
Need to adjust your idle? http://zilvia.net/f/s-chassis/395413...-pictures.html |
|
04-05-2013, 03:09 PM | #6 |
Leaky Injector
Join Date: Aug 2008
Location: salina, ks
Age: 39
Posts: 83
Trader Rating: (5)
Feedback Score: 5 reviews
|
i have had the 740s since 2008, it ran perfect before. just completed an engine bay tuck/paint.
powerFC 414BN014 to4e 272 BC cams, springs, retainers FMIC w/3" piping walbro pump nismo fpr
__________________
Don't mix booze and car batteries...it gets expensive, quickly. |
04-05-2013, 06:16 PM | #9 | |
Zilvia Junkie
Join Date: May 2008
Location: Quebec
Age: 36
Posts: 306
Trader Rating: (1)
Feedback Score: 1 reviews
|
Quote:
Also, you could check the temperature on your power FC.
__________________
Life is a beat to beat |
|
04-05-2013, 08:20 PM | #13 |
Post Whore!
|
Stock SR is 43psi with vacuum unplugged and 37psi with vacumm plugged in.
Also, timing needs to be set to 15* BTDC. If you're running at TDC than that will cause a rich condition.
__________________
|
04-08-2013, 09:17 AM | #15 |
Zilvia Junkie
Join Date: Sep 2012
Location: Tulsa Oklahoma
Age: 31
Posts: 313
Trader Rating: (0)
Feedback Score: 0 reviews
|
This.
Happened to me. You need to pull injectors and check first. Once you figure out the problem, you MUST change the oil or you will spin a bearing.
__________________
Ka24 t3/t04b + Z32MAF + 550 subys + Walbro 255 + enthalpy Tune + 91 octane |
Bookmarks |
Thread Tools | |
Display Modes | |
|
|