Master Chief

Sorry if this is in the wrong place, i just couldnt find an answer.

I have a set of SportMax 17"x9 wheels, i want to fit for daily drive.
Hi guys.

I will be runing with 235/40 on front and 245/40 (with future plans for 255/40) on the rear, tyres.


I was wondering, what offset would i need, to have the rear wheels sit just a bit out - needing a bit of arch flaring, and the front wheels sit flush with the font wingm or allso with a bit of esaly doable flaring ?

I need to decide what spacers to get, as the wheels ar ET35.

I really want the ARCH flerring (not sure this is how its called) on the rear, so i want to get things looking right.

These are the tyres i have now, so please dont send me to buy others.



Is ET10 on the rear going to do the job, and is ET10 on the front too much ?

I was thinking of getting 25mm spacers, all around.


If anyone has some pictures of how these offsets could look, i'd appritiate it.

Thanks,
Dany.

Master Chief

Can anyone help out on this ???

bbejj123

wheel fitment thread there should be a setup like this

__________________

Z33dori

17x9 +0 will fit perfect... if u have coilovers

for better info, and pics of fitment with those wheels plz use the wheel fitment thread

#/f/showthread.php?t=129865

__________________

golfer17

I got a similar setup so I suppose I'll post it

235/40-f w/ 17x8 +25
255/40-r w/ 17x9 +38

Imo, these wheels sit very flush, though I know some prefer their rear wheels to stick out a little more than this (which I would too, but they don't make the wheel im using in a 17x10 +38). Now that I've made measurements with this setup, I'm going with 245/40-f and 275/40-r for my next tire setup. This is all with tein s-tech springs and tokico struts too, so once I get my stance coilovers installed (waiting on the new version 3 ruca's from spl), there should be a little more room. Hope that helps.

__________________

Master Chief

I am looking at that tread, but couldnt find a streight answer.

Will 235/40 17" on a 9" Rim with offset 10 - be ok ?
What will i need to do to the front fender, to make it fit ?
Rolloing/pulling/.... ?

Thanks.

golfer17

17x9+10? Maybe with a ton of negative camber. I mounted 17+9+15 w/ 235/40 on the front of my car and they stuck out quite a bit (heck, I had to roll the rear to get them to fit there). But I also try not to run any negative camber.

__________________

Z33dori

if u don't wanna run Negative then get a really gay offset...

__________________

aznpoopy

for reference i've had 225 and a 245 on a 9+15 up front, 245 and a 255 on 9+15s in the rear as well. lowness has varied between tucking just the tip of the tire to tucking a good inch or so.

assuming you go with a similar height...

imo a 9+10 /w a 235 will fit fine in front with a modest 2ish degrees of camber or so. no way you can get away without a roll and harness relocation.

9+10 /w a 245 /w 2ish degrees of camber will probably leave the wheel face very slightly sunk, but overall flush to the tire. you will very probably have to pull or roll.