Nismo 240

I think i solved the position light Problem.

I noticed a previous thread where someone wired up there lights by eliminating the ground wire, i dont know about yall but i didnt like the way it work they blinked way to fast for me so i did some thinking and messed around and figured out how to wire it up and it work like it is supposed to. i just did this so how long it works im not sure but this is what i did.

1) I took the light and drilled a 5/8 hole in it (off to the side of the existing hole) and notched it for the locking tabs




2) Cut the wires behind the connector on the on the blinker socket to remove the connector and socket.

3) What i did for this step is i used the connectors from the front and rear side makers.
Take the red wire on the existing harness and connect it to the positive wire on one socket ( You will need to use two different bulbs for this to work make sure on this plug you use the 194 bulb for your running lights)

Then you take the light green wire and connect it to the positive wire on the other connector ( This will be for the blinker make sure you use the bulb type 921).

Then you take both of the ground wires from the connectors and connect them to the ground wire on the existing harness and TAAAADAAAHHHH you have blinkers and running lights that work great.




This is a video of them working.




Please Give feed back yall let me know if i screwed up thanks.

Nismo 240

Correction here is a link to the video Thanks.

video-2011-10-07-19-17-05.mp4 video by bignismo240 - Photobucket