s14 and taller drivers - Zilvia.net Forums | Nissan 240SX (Silvia) and Z (Fairlady) Car Forum

Tcella17 · 02-20-2014, 09:54 AM

I have a 95 s14 and I'm on the taller side. I'm going to have to make some custom mounts for my bucket seat in order for me to fit and build a cage. Anyone ever run into this problem?

Sent from my iPhone using Tapatalk

husker240 · 02-22-2014, 07:02 PM

i am too tall for my s14, i have been looking into aftermarket seat with fixed or low profile brackets. but the problem i have been finding is that measurement are iffy from vendor to vendor.

Kingtal0n · 02-24-2014, 12:37 AM

Ive seen a thread on here, or freshalloy, where they cut the floor slightly to move the seat down a few inches. Or an inch. Do some searching there is a WHOLE how-to with that.

It wasn't a hack job, it was clean and done right.

02-20-2014, 09:54 AM	#1
Tcella17 Join Date: Feb 2014 Posts: 1 Trader Rating: (0) Feedback Score: 0 reviews	s14 and taller drivers I have a 95 s14 and I'm on the taller side. I'm going to have to make some custom mounts for my bucket seat in order for me to fit and build a cage. Anyone ever run into this problem? Sent from my iPhone using Tapatalk

02-24-2014, 12:37 AM	#3
Kingtal0n Post Whore! Join Date: Jul 2005 Location: South Florida Age: 38 Posts: 4,649 Trader Rating: (17) Feedback Score: 17 reviews	Ive seen a thread on here, or freshalloy, where they cut the floor slightly to move the seat down a few inches. Or an inch. Do some searching there is a WHOLE how-to with that. It wasn't a hack job, it was clean and done right. __________________ 5.3/4l80e/turbo 240sx playthrough: https://tinyurl.com/turbo240

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

02-22-2014, 07:02 PM	#2
husker240 Join Date: Nov 2012 Location: lincoln nebraska Age: 29 Posts: 8 Trader Rating: (0) Feedback Score: 0 reviews	i am too tall for my s14, i have been looking into aftermarket seat with fixed or low profile brackets. but the problem i have been finding is that measurement are iffy from vendor to vendor.