Blowing ALT fuse, BLACKTOPs14 in S13 - Zilvia.net Forums | Nissan 240SX (Silvia) and Z (Fairlady) Car Forum

rhd_sw20 · 04-10-2008, 07:04 PM

Hey guys, just finished doing blacktop swap on my s13. Car runs and starts fine, but Im blowing my ALT fuse. I have continuity between the thick wire on the alt to one spot on the fuse location. Its reading full battery voltage across the fuse.

Its the s14 ALT, but I changed the fitting on it where the thick wire goes so the s13 wire would work for it. There is no rubber on it, but I dont see how this could cause any problems.

Your insite to this would be definatley apprieciated!!!

sblack13 · 04-10-2008, 07:04 PM

did you cross your alternator wires on the lower harness?

nrg · 04-10-2008, 07:06 PM

did you accidentally throw out the protective washer piece that goes on the stud for the alternator positive terminal?

Nackers · 04-11-2008, 10:35 AM

Quote:

Originally Posted by nrg

did you accidentally throw out the protective washer piece that goes on the stud for the alternator positive terminal?

Exactly what happened with my redtop. Just use another nut and just keep that wire from touching the alternator housing.

aNskY · 04-11-2008, 10:37 AM

Quote:

Originally Posted by nrg

did you accidentally throw out the protective washer piece that goes on the stud for the alternator positive terminal?

Yeah, either that or you torqued the nut too much and broke the plastic washer. Has happened to me and it took a while to figure out what the hell was going on

04-10-2008, 07:04 PM	#1
rhd_sw20 Zilvia Member Join Date: May 2006 Location: calgary Posts: 210 Trader Rating: (0) Feedback Score: 0 reviews	Blowing ALT fuse, BLACKTOPs14 in S13 Hey guys, just finished doing blacktop swap on my s13. Car runs and starts fine, but Im blowing my ALT fuse. I have continuity between the thick wire on the alt to one spot on the fuse location. Its reading full battery voltage across the fuse. Its the s14 ALT, but I changed the fitting on it where the thick wire goes so the s13 wire would work for it. There is no rubber on it, but I dont see how this could cause any problems. Your insite to this would be definatley apprieciated!!!

04-10-2008, 07:06 PM	#3
nrg Zilvia FREAK! Join Date: Mar 2004 Location: CA Age: 36 Posts: 1,571 Trader Rating: (1) Feedback Score: 1 reviews	did you accidentally throw out the protective washer piece that goes on the stud for the alternator positive terminal? __________________ driftingisgay.com

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

04-10-2008, 07:04 PM	#2
sblack13 Zilvia FREAK! Join Date: May 2005 Location: Seattle Age: 34 Posts: 1,016 Trader Rating: (10) Feedback Score: 10 reviews	did you cross your alternator wires on the lower harness?