Replacing pillow ball tension rods that are seized - Zilvia.net Forums | Nissan 240SX (Silvia) and Z (Fairlady) Car Forum

Kanto · 11-04-2013, 04:50 PM

So I wanted to replace my tension rods so I purchased some SPL for my S14. As I go to remove them, it seems the previous owner had installed some pillow ball ones as well. As I try to remove it, I realized the metal bearing? seized onto the bolt that held the bushing end in place. Is there anyway to remove them?

Much help would be appreciated

BoredEE · 11-04-2013, 07:14 PM

BFH

Big freaking hammer

If that fails then get your self a dremel or angle grinder to cut off the head of the bolt, or if needed cut through the spherical bearing.

Or drill out the head of the bolt. But it will be easier to grind the bolt head off.

11-04-2013, 04:50 PM	#1
Kanto Leaky Injector Join Date: Apr 2009 Location: San Francisco Posts: 111 Trader Rating: (2) Feedback Score: 2 reviews	Replacing pillow ball tension rods that are seized So I wanted to replace my tension rods so I purchased some SPL for my S14. As I go to remove them, it seems the previous owner had installed some pillow ball ones as well. As I try to remove it, I realized the metal bearing? seized onto the bolt that held the bushing end in place. Is there anyway to remove them? Much help would be appreciated

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Hybrid Mode Switch to Threaded Mode

11-04-2013, 07:14 PM	#2
BoredEE Leaky Injector Join Date: Aug 2009 Location: Chicago, IL Posts: 138 Trader Rating: (0) Feedback Score: 0 reviews	BFH Big freaking hammer If that fails then get your self a dremel or angle grinder to cut off the head of the bolt, or if needed cut through the spherical bearing. Or drill out the head of the bolt. But it will be easier to grind the bolt head off.