Innovate MTX-L question/issue - Zilvia.net Forums | Nissan 240SX (Silvia) and Z (Fairlady) Car Forum

R3cK · 07-05-2013, 06:13 AM

Wired and calibrated my MTX-L
worked fine while not driving and playing with the throttle.
then i drove only some feet and suddenly it shows the E2 code again

E2 means no sensor detected like when you have to calibrate it.
any ideas?

i read about people got the same issue and even replaced the sensor but had the same problem after that.
no solution so far..

tobroketobuildarealcar · 07-06-2013, 12:57 PM

Make shure you have a good ground for the electrical circut

I have seen so many odball problems happen bc of a bad ground

07-05-2013, 06:13 AM	#1
R3cK Zilvia Member Join Date: Nov 2011 Location: bavaria Posts: 159 Trader Rating: (0) Feedback Score: 0 reviews	Innovate MTX-L question/issue Wired and calibrated my MTX-L worked fine while not driving and playing with the throttle. then i drove only some feet and suddenly it shows the E2 code again E2 means no sensor detected like when you have to calibrate it. any ideas? i read about people got the same issue and even replaced the sensor but had the same problem after that. no solution so far..

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Hybrid Mode Switch to Threaded Mode

07-06-2013, 12:57 PM	#2
tobroketobuildarealcar Zilvia Junkie Join Date: Feb 2013 Location: Florida Posts: 508 Trader Rating: (0) Feedback Score: 0 reviews	Make shure you have a good ground for the electrical circut I have seen so many odball problems happen bc of a bad ground