Dsmguy1993

Alright so I sealed my sr20det s13 upper oil pan with Hondabond Ht permatext ultra grey equivalent basically but I chose hondabond ht. Anyways I prepared it very well cleaned off all the silicone and used brake cleaner to prep the surfaces I had the engine upside down also when I did this to make sure no oil can touch it. I never ran my engine yet but I did fill it up with oil the first time I mounted it in my s13 I took it out again because of the fact that I wanted to double check if all my rod caps were on correctly before starting and possibly damaging my sr cinder #1 cap was backwards but I put it in correctly so its all good I never ran the engine so the bearing was fine. Anyways Im confused and I wanted to know one question are upper oil pan leaks common on these engines?! Perhaps oil dripped onto the silicone seal from the top of my engine after I turned it right side up because it was upside down for a while. The oil was just residual oilI of course drained it before I put it on my engine stand thats why theres oil in there. its only
on one part I can lightly feel oil here I attached a picture with me pointing at it if that https://ibb.co/zb6WM5g
https://ibb.co/8NN8V7F
https://ibb.co/RvdDn90