Rivnut/Nutsert experts needed! - Zilvia.net Forums | Nissan 240SX (Silvia) and Z (Fairlady) Car Forum

jr_ss · 08-29-2020, 10:09 PM

Theoretically, he could just drill a couple pilot holes at the 4 corners of the nut and weld through the sheet metal to the nut. It’ll serve the same purpose as having access to the backside without cutting a huge hole. Put the bolt in from the opposite side of you can, thread the “captured” nut on the outside and mark where you need to drill. Reverse order and a few hits with a mig and you’re done...

08-29-2020, 10:09 PM	#16
jr_ss Post Whore! Join Date: Dec 2005 Location: Pa Posts: 6,052 Trader Rating: (34) Feedback Score: 34 reviews	Theoretically, he could just drill a couple pilot holes at the 4 corners of the nut and weld through the sheet metal to the nut. It’ll serve the same purpose as having access to the backside without cutting a huge hole. Put the bolt in from the opposite side of you can, thread the “captured” nut on the outside and mark where you need to drill. Reverse order and a few hits with a mig and you’re done... __________________ My SR20VET

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode