Zilvia.net Forums | Nissan 240SX (Silvia) and Z (Fairlady) Car Forum - View Single Post

Tw1st3d · 12-08-2012, 07:10 PM

picked up a tial MVR 44mm I will run the tubes for this on the manifold when it's in the car so i know were to put it.

Out with the KA! yanked the bitch in one hour flat.

machined a new shift knob for next season for an old knife

AN Fittings for oil catch can setup.

welded the waste gate holes in the holset

got the motor naked for seals clean up timing belt upgraded 2jz oem water pump etc.

12-08-2012, 07:10 PM	#6
Tw1st3d Zilvia Member Join Date: Dec 2010 Location: Oregon Age: 30 Posts: 211 Trader Rating: (0)	picked up a tial MVR 44mm I will run the tubes for this on the manifold when it's in the car so i know were to put it. Out with the KA! yanked the bitch in one hour flat. machined a new shift knob for next season for an old knife AN Fittings for oil catch can setup. welded the waste gate holes in the holset got the motor naked for seals clean up timing belt upgraded 2jz oem water pump etc.