Thread: The fabrication thread.
View Single Post
Old 12-05-2013, 10:52 AM   #5501
blockedwizard
Zilvia Member
 
blockedwizard's Avatar
 
Join Date: Apr 2011
Location: L.I., NY
Posts: 214
Trader Rating: (11)
blockedwizard is an unknown quantity at this point
Quote:
Originally Posted by kingston240 View Post
For 16g stainless your amps are about right.

Don't bevel 16g.
Work on your torch angle and speed. Your putting a lot of heat into the tube (wide haz) so i can tell your going too slow.

1/16" filler on 16g (1/16" wall tube) stainless is tough. Use a smaller filler and it will flow a little nicer.
Alright thanks Kingston ya I need to get some .45 filler and definitely speed up and keep amperage under control. Appreciate the feedback guys!!!!
blockedwizard is offline   Reply With Quote