|
i was finally able to get spark but not the way its meant to. so on my harness on the 4 pin side of the igniter chip it has a wire splitting off of the ignition signal 1 i dont know if thats factory or not but i ended up wiring that to the black and red wire that goes to the chassis connectors right where i have the 12v for the coil harness connector. and when i use a test light and put the alligator clip on a ground and then poke the wires on the 5 pin side of the igniter with the prong of the test light it sparks all 4 coils at the same time and i have tested this multiple times doing different things and this is the only was ive gotten it to spark. also all my ignition wires have at least 10v now which before they had 0v. i ended up taking out my CAS and when i turn it by hand no spark still it turns on the injectors and thats it.
|