Here are the specs and pics of the Beast motor setup. Enjoy!
Long Block Build Specs:
· Peak Performance 2.35L 91mm Billet stroker crank
· Custom 90mm JE Pistons
· Darton cast iron cylinder sleeves
· CNC ported cylinder head (flow benched)
· Ferrea stainless +1mm oversize valves on intake and exhausts
· Custom copper headgasket with custom stainless wire seal on the cylinder head and block
· Carillo con-rods
· WPC treated ACL race bearings for mains and con-rods
· WPC treated rocker arms (all – new)
· WPC treated piston rings
· Tomei 280/280 solid cams
· Tomei double valve springs w/retainers
· Tomei solid pivots with custom shims (all measured and done)
· Tomei upgraded large oil pan
· Tomei Rocker Arm Stoppers
· Toda Racing adjustable cam sprockets
· OEM oil pump, OEM water pump, new timing chain parts and seals
· GREX large cylinder head studs
· ARP main studs
Built for 1000hp+ drag setup!!!
The Long 45 days awaited beautifully crafted Full Race True Twin Scroll 30R turbo kit is finally here. Enjoy the following pics. Thanks to Geoff and the Full Race team for making this masterpiece and delivering on time!
My son's face says it all!
Here's the Greddy Manifold and Rail with the N15 t.b. before and after pics, some say it's too fancy but I like it clean and polished up.
All Earl's plumbing, took a while to figure out the right and perfect setup for custom made turbo and fuel lines. Lots of measuring and fitting went into this stuff. But hey not bad for my first time with AN assembly and install.
The problem here was I had built this motor and assembled all the bolt on parts but I had to get it down the stairs somehow! Believe it or not me and my bro brought this thing down a narrow flight of steps by ourselves on this custom made wooden dolly thingy!
It's finally in the car!!!
Thanks to Matt Castle for the fab. work on the bay and everything that needed to be custom made! Thanks to Yonathon and Sirac for giving me a hand in dropping the Beast in and much more.
Injector Dynamics 1000cc high impedance injectors are here. Took some Vaseline to get these babies in just right. Good idea Sirac!
I will keep this thread updated as I get more done on the Beast!