Zilvia.net Forums | Nissan 240SX (Silvia) and Z (Fairlady) Car Forum - View Single Post

Broadfield · 09-28-2011, 07:32 AM

Quote:

Originally Posted by fliprayzin240sx

Well, I cut a corner that I know now I screwed up on. I hooked up the H2 Black/White wire before the E-brake switch so it's seeing (+) instead of (-), figured I'd need to hook it up after the switch so its grounded.

Also I gotta double check how I wired up the H2 Brown wire for the Brake Shutdown. When I was testing the remote start, it was giving me 5 flashes, pointing that the brake wire is active. I tested it, pressing the brakes and it gave me 7 flashes, stating that I have not initialized the MT Mode. I'm guessing I tapped the wrong wire on this one too, just like above.

Then I still gotta figure out why my parking lights doesnt blink with the chirp. I jumped the fuse inside the module to (+), I jumped the inside, not the outside 2.

Lastly, I still got my power door lock issue. No clue why its not working, tapped the 3 pin door lock connector. Blue to unlock the Brown wire and Green to lock the Lt Green/White wires at the SECU. Just to make sure, I just tap them and not cut them off correct?

I'm attempting to follow the Installation Points in the quick guide. I've learned the Tach (LED turned constant) and thats about it. Nothing else seems to work. Tried to do a Shutdown Diagnostic, nothing. Clicked on remote start and I get the MT mode not initialized (7 beeps/flashes). Can't do the MT mode initialized (turn the engine on, set the e-brake up, pressed and released the brake, pressed any button on the remote...nothing). Tried going into Programming to set the Menu 3, Item 8, Opt 2...can't even do that. Opened the door, turn the ign on/off, pressed/hold Control Button...nothing beeped.

Needless to say, this thread is gonna be popping for a while till I work my issues out.

A few things to check:

Is your door trigger sending signal to the Viper when the door is open? You can not program the system or remote start it in manual trans mode if the Viper does not see this signal. Test the green wire at the brain and make sure you have a negative signal when you release the door pin... obviously the other door needs to be closed.
Are you doing the correct remote start procedure? With car running and in neutral: foot on the foot brake, e-brake on-off-on, release foot brake, remote start vehicle, turn key off(vehicle should stay running at this point), open door, close door and then press lock on the Viper remote. If done correctly, then the engine will shut off when you lock it. Of course you said your e-brake input is wired incorrectly and your brake might wired incorrectly... so the remote start will absolutely do noting if you have these wrong.
As for the door locks, did you test the lock wires in the car to confirm they are what you think they are? Each wire will go to negative when you hit the related button. If the wires go to negative when you hit the lock/unlock switch then you have the correct wires... so you can rule that out. You may have a bad brain or some other issue.

Get the e-brake and foot brake wires straightened out then we'll go from there.