Zilvia.net Forums | Nissan 240SX (Silvia) and Z (Fairlady) Car Forum - View Single Post - DIY s13 chuki lip (gen4 Accord), side skirts (gen3 Legacy, gen2 Outback)

***dorkidori_s13*** · 07-10-2012, 10:30 PM

just to keep in spirit with the thread, i fitted a 94-95 accord rear bumper lip to my hatch over the weekend. i think i might go back and snag a 96-97 rear lip and fit it as they extend further in the back. also thinkin about fitting up some 94-97 accord side skirts as they would go REALLY well with the chuki front lip and accord valances

fitting these is NOT for the faint of heart, theres a lot of cutting involved along with making custom mounting brackets (i just used some thin tin molding and 3m permanent/exterior double sided tape) but the outter pieces fit the curve of the hatch bumper PERFECTLY!!!

i think i may install my 91-92 accord front lip i snagged this weekend as well

07-10-2012, 10:30 PM	#92
*dorkidori_s13* ITS LISA'S FAULT!!! Join Date: Jun 2003 Location: Las Vegas Age: 39 Posts: 7,331 Trader Rating: (41)	just to keep in spirit with the thread, i fitted a 94-95 accord rear bumper lip to my hatch over the weekend. i think i might go back and snag a 96-97 rear lip and fit it as they extend further in the back. also thinkin about fitting up some 94-97 accord side skirts as they would go REALLY well with the chuki front lip and accord valances fitting these is NOT for the faint of heart, theres a lot of cutting involved along with making custom mounting brackets (i just used some thin tin molding and 3m permanent/exterior double sided tape) but the outter pieces fit the curve of the hatch bumper PERFECTLY!!! i think i may install my 91-92 accord front lip i snagged this weekend as well __________________ Bought something from me??? POST A REVIEW HERE!!!