Sorted the loom in the drivers wheel well Today, was always cautious of it, so i always had that extra 2 inches i could have gone lower but didn't for fear of chewing it up, so i said id tie it up so i wouldn't have to worry about it again,
this is what it looked like it was actually resting on the plastic shield,
got to it just in time
pulled it out as much as i could to see what i had to play with
cut a notch out so the loom would run along the lip
then treated and fiberglassed around the cut metal so it was in no danger of sharp edges cutting into the loom,
undersealed everything while i was at it
and tied it up with the largest zip tyes i could find
thats how it should have been done from the factory Nissan
where i had cut the notch sits nice
had to run the bonnet cable under the lip as there wasnt enough slack to bring it over,
throwing on the wing i found out i had over done it
the wing wouldn't go back on ... so had to adjust the loom again until it would stop fowling the wing,
still its out of harms way so i gained a good bit of extra clearance.
