mikeroy420

Just wondering about my connections for the power window module. What I am unsure about is the passenger side sub switch. Do I connect before or after the sub switch? Do I need to wire the tilt sensor into the sensor bypass relay? Thanks

530T Window Automation Module Wiring

H1/1 Violet- ground path motor #1 --> chassis ground
H1/2 Green- driver’s side down motor (motor side) --> driver side door blue (motor side)
H1/3 Blue- up, motor (motor side) --> driver side door green (motor side)
H1/4 Red- Constant 12V --> from battery or white at ignition harness
H1/5 Black- chassis ground --> chassis ground
H1/6 Violet/Black- ground path motor #2 --> chassis ground
H1/7 Green/Black- passenger side, down motor #2 --> passenger side door blue or red/white (motor side)?
H1/8 Blue/Black- up, motor #2 passenger side --> passenger side door green or red/black (motor side)?

H2/1 Brown- up, switch #1 (switch side) --> drivers side door green (switch side)
H2/2 White- driver side down switch #1 (switch side) --> drivers side door blue (switch side)
H2/3 Red/White (-) - auxiliary input --> connects to H2/6 white/violet on alarm
H2/4 Orange (-) - ground when armed --> connects to H1/12 orange on main alarm harness
H2/5 Grey- output during activation --> wires to relay to bypass audio, motion and tilt sensors (see relay connections below)
H2/6 Brown/Black- up, switch #2 passenger side (switch side) --> passenger side door green or red/black (switch side)?
H2/7 White/Black- down, switch #2 passenger side (switch side) --> passenger side door blue or red/white (switch side)?

Sensor Bypass Relay

85- H2/5 Grey from 530T
86- 12V (fused) from battery
87- N/A
87A- Red wire from tilt, audio and motion sensor
30- Red wire from alarm