so finally bit the bullet and bought some over-fenders, i need 50-60mm, but i think any 50mm overs look bulgey and shite, the only exception is the wisesquare overfenders
i like the way the lil pull around the wheel stops the whole wing being pushed out.
but you can see the problem with them that grove that comes out and goes along the bumper looks daft,
so i decided to get 30mm overs off drive n style, and cut and achieve the pulled look around the wheel myself,
waht it looked like with just the pulled fender about 5-6 deg camber :hurl: car looks broken LOL
so set the wheels to about 1 deg negative camber as opposed to the usual 5 and test fitted the wings,
took them off and started marking out for cutting
trying to work out the right angle of the slope and this is the best photo i can find :/ there is going to be alot of trial and error.
then these arrived today forgot i had ordered them doubt ill fit them as the 50/50 are really growing on me now nice and simple
will fit them and decide then
also got a gizzmo boost controler and z32 AFM starting to get stuck for space in the room
----------------
dose anyone know if i can cut the overs along this line marked in pencil?
if i push it into place it warps around in a few diffrent places? but if i cut it and pin it down below it looks alot better.
so cut out and pulled them a extra 25mm, trying to get the angle of the slope right,
think ill go with this, so just get a peice of perspex now and warp it to the 3 points draw a line along it and i have my upper curve, cut that, fit brackets
and start fibreglassing
anyone have any tips???
--------
fiberglass set from last night, offered it up STILL ALOT OF WORK left to do!!, another few layers of fiberglass start getting down to the basic shape, but its getting there.
front before i removed the bracket
rear
fitted
yeh? neh?
----
est the last photos where taken i decided i didnt like the front of the drivers side pull, it was not uniform so i cut it up and did it again and it looks alot better passanger side all glassed up so now it get to the hard part cutting and sanding to achieve the correct shape, want ot use as litte filler as possible so im high building the fiberglass, grinding it with a grinder before sanding