|
OK Thanks for pics for clarification. I understand aligning the lower knuckle to rack, but if I remove the upper knuckle bolt and slide the shaft up and down in the knuckle it does not stop or seat in the knuckle. I do not see mark on knuckle or shaft indicating how to far to insert. Only reason I am asking is because if I have it fully inserted as far as possible, the limiting factor is the Circlip at the bearing up by the splines, and I get a little steering wheel rubbing on the plastic column housing. If pull it back a little to clear the housing, there is a few mm of space between circlip and bearing and it appears there is enough spline engagement into the knuckle, so I was just trying to confirm if whether my assumptions were correct.
|