|
For the hand brake, there's a bolt you can turn under the handle. There's a small hole you can put 10mm socket. Try to tighten or lose.
If you remove the center console, you can see how the switch works. Check that.
One more thing, floaty in the brake master cylinder is supposed to trigger the switch when the fluid goes low, but sometimes switch goes bad.
Unplug the harness on brake master cylinder and see.
Mine was that way, so I had to leave it unplugged.
Eventually, I swapped it out with z32 master cylinder and everything was fine.
__________________
courtesyparts.com
|