Quote:
Originally Posted by blades13.5
I've spent $650+ on the zietronix. I purchased it because of its ability to monitor and display MANY functions w/o a computer or a ton of gauges. (fuel pressure, Oil Pressure, Boost Pressure, AFR, Lambada, EGT, RPM, TPS %, Oil/water temp etc.) The online reviews I read were very good as well as the customer support. I read over some forums
"The zietronix analog output works fine with the aem ems. You just have to set the scaling and make the EMS match the zietronix output."
"Zietronix actually created the system for use with the AEM before AEM had even created its own Eugo controller."
I just still don't know if they require separate sensors or if the wiring can be spliced together for both systems. I mean, they both require the same sensors. And the MAP sensor and the Boost Pressure sensor are BOTH 3.5 bar maps sensors, So, Can it be used for both functions or do you need 2 seperate sensors? and when you wire it up does the wiring go to both systems(Spliced or 2 seperate sensors) or first to the wideband/EMS and then to the secondary?
|
A few thoughts because I haven't worked directly with the zietronix...
-Is there an auxilary output from the AEM that you can configure to send the Load pressure value out to the zietronix? That is probably how it's supposed to work. MAP input into the AEM EMS then an auxilary output sending data out to your display...
-Another thought does the zietronix need it's own separate map to work? or to read boost? Maybe this is the issue could also be an issue. See if the zeitronix will accept an aux input - which would be an aux output from the AEM unit for boost/load to display....this...at least in theory is how it should work...
Should be pretty basic if you can just do this....and this is how all the Haltech systems work. We just pull data in and send it back out via configured auxilary outputs if we need to send the data elseware.