Zilvia.net Forums | Nissan 240SX (Silvia) and Z (Fairlady) Car Forum - View Single Post

jakerps13 · 11-20-2008, 11:43 AM

2 or 3 of the bolt holes need to be moved because they don't line up. You'll need to do a bit of port matching because the ports aren't identicle from gtir to rwd.

As everyone else has been saying it obviously points toward the firewall. What I did was cut the runners and added about 30 degrees downward so the plenum fits under the hood. Otherwise it's way to high.

Here's before cut

Here's after 30 degree

After you get all the moch up shit done, you'll need to change your tps wires because it'll read backwards, make your own throttle cable and bracket, rewire the gtir IF you want iacv, and you'll obviously have to go topfeed. If you don't know how or don't want to sync itb's don't bother with the setup. You're going for performance and it comes at a cost of maintenance.

11-20-2008, 11:43 AM	#11
jakerps13 Zilvia Member Join Date: Nov 2003 Location: Appleton, WI Age: 37 Posts: 171 Trader Rating: (0)	2 or 3 of the bolt holes need to be moved because they don't line up. You'll need to do a bit of port matching because the ports aren't identicle from gtir to rwd. As everyone else has been saying it obviously points toward the firewall. What I did was cut the runners and added about 30 degrees downward so the plenum fits under the hood. Otherwise it's way to high. Here's before cut Here's after 30 degree After you get all the moch up shit done, you'll need to change your tps wires because it'll read backwards, make your own throttle cable and bracket, rewire the gtir IF you want iacv, and you'll obviously have to go topfeed. If you don't know how or don't want to sync itb's don't bother with the setup. You're going for performance and it comes at a cost of maintenance. __________________ Lower than a pornstar's morals.