Zilvia.net Forums | Nissan 240SX (Silvia) and Z (Fairlady) Car Forum - View Single Post

mattro · 07-29-2009, 03:47 PM

ive been covering this for some time on the sr20 forum but i realised i didnt have it here. so here goes

here is a list of mods so far.

engine/tranny/stiff parts
cometic 1.01 hg
255 walbro
megan fpr w/ gauge
CC stage 2 carbon kevlar clutch
72lb msd
jgy fuel rail
garret t67
blitz dd bov
tial 38mm gate
top mount mani
3"dp
3" cat delete
apexi style dual 3" cat back
cx racing fmic
welded dif
RPsport sub frame supports zilvia special FTW!
front/rear/under strut tower supports another zilvia special!
JWT ECU
Greddy EMU
Nismo mounts

inside.
5pt harness (driver and passenger, i like the way it makes her tittys look)
knock off boost gauge
aem wideband
oil press, water temp ultra light gauges with center vent mount
kirkly alu road race seat (for me)
stripped inside, not by my choosing.

outside.
g20 rims white
stickers.
wide body to cover the pushed in 1/4 panel

and pics!

here is how i got the car.

believe it or not, it actually ran. kind of.

so summer rolls arounds and im getting tired of the blown turbo, half assed everything, so i start taking it apart. before i knew it i was balls deep into a full on build.

here we go again!

BTW^ that is another zilvian's doing.

and then the new parts started rolling in.

oh and these are the old rear sub frame supports the rp sport ones replaced

07-29-2009, 03:47 PM	#1
mattro Zilvia Junkie Join Date: Dec 2008 Location: henrietta, ny Age: 32 Posts: 478 Trader Rating: (4)	rochester ny my 91 build. ive been covering this for some time on the sr20 forum but i realised i didnt have it here. so here goes here is a list of mods so far. engine/tranny/stiff parts cometic 1.01 hg 255 walbro megan fpr w/ gauge CC stage 2 carbon kevlar clutch 72lb msd jgy fuel rail garret t67 blitz dd bov tial 38mm gate top mount mani 3"dp 3" cat delete apexi style dual 3" cat back cx racing fmic welded dif RPsport sub frame supports zilvia special FTW! front/rear/under strut tower supports another zilvia special! JWT ECU Greddy EMU Nismo mounts inside. 5pt harness (driver and passenger, i like the way it makes her tittys look) knock off boost gauge aem wideband oil press, water temp ultra light gauges with center vent mount kirkly alu road race seat (for me) stripped inside, not by my choosing. outside. g20 rims white stickers. wide body to cover the pushed in 1/4 panel and pics! here is how i got the car. believe it or not, it actually ran. kind of. so summer rolls arounds and im getting tired of the blown turbo, half assed everything, so i start taking it apart. before i knew it i was balls deep into a full on build. here we go again! BTW^ that is another zilvian's doing. and then the new parts started rolling in. oh and these are the old rear sub frame supports the rp sport ones replaced Last edited by mattro; 11-07-2009 at 01:28 PM..