Originally Posted by azsr20det

Hey guys/gals/others

I just completely redid my brake system and hubs, installed the villans drift dual caliper setup and 5 lug hubs, painted the calipers and knuckles while i was down there and installed adjustable camber and toe arms.

First question is in regard to the front slide pins on the caliper bracket, when doing the install i found the upper slide pin on both size was siezed and did not slide or even come out so i picked up new slide pins, boots, and caliper brackets, one of the slide pins has a rubber piece at the bottom, does that one go on top or bottom? I think thats the top because the bottom one that did pull out didnt have it but wanted to be sure

My second question is in regard to the rear caliper piston. How do I get it to recess back into the caliper so I can get it over the new pads? The front I did by opening the fluid res cap and using a C clamp and one of the old pads to push the piston back so i could get it over the new pads but on the back this doesnt seem to work. How do I get the rear piston back in?

Thanks