|
ok most likely its ur throw out bearing
not that it bad but the bearing face is wrong
i jst installed a xtd stage 3 w fly wheel and used their bearing thinking oh its new
even tho it didnt look the same as the oem replacement one i put on 6mo when i upgraded my sr
well i took it off found the retaing clip for the TOB was not right i put another one
pt it back together and still the same issue..
when i push in clutch the noise goes away..
the oem rplace ment is the way to go for sure
im gunna pull mines on sat
and im driving car 46mi every day
as long as ur for sure u torqued fly wheel bolts
for sure this is the issue...
dont even get a ka TOB either cause i ordered that one first and it doesnt have the same face as a sr oem so it will make noise.
especially on any strong clutch
u can only install a TOB one way if u put it on wrong it could make this noise but it would be different
also u can bench press the tranny in as long as u loosen the engine cross member
and jack up the harmonic balancer
and its not that hard i did it all by myself....
__________________
 シチサｎ w/ka20det:in progress
シチサｎw/sr20det:stolen
|