Lost8lives

i used the S15 core support but you dont have to you can cut holes out for the head lights. I bent the top of the S14 core support up when i stabbed the engine and i want a clean look..

Drill the spot welds out and pull it out i just took the top half off since the bottem half is the same and it was less work.

I took a reg. drill bit and drilled a little on each the grinded the bit down on the end. I did this 3 times untill the drill bit was flat on the end. this alowed me to keep from drilling all the way threw both sheets of metal..

this guys right up is great on the replcement

#/f/tech-talk/239722...ement-how.html



























Buy a punch and flange i got one at harbor freight for 39.99 not on sell well worth it do not butt weld or over lap it with out the flange tool butt welding it will make it week and over lapping it you will need a bunch of body filler

this is the best places i could find to cut at i had to trim both sides a few times remember it is EZer to make it shorter than longer so be cairfull and take your time cut a little at a time