Ok so it seems I was right. I pulled the cams out, rockers seemed fine. However, the bank 1 intake lifter had air in it.
FSM says that if you can push the lifter plunger with your finger more than 1mm, it will cause a noise and requires bleeding. Mine went down like 5mm.
Pulled it out and bled it, now it holds up fine to the finger test.
85% sure that this was the problem.
However, I made the mistake of cheapening out on a new torque wrench so I sorta snapped a couple of cam retainer bolts. Not to worry, I will drill them out tomm (gotta be extra careful though), but does anyone know where I can find a new set?
Also installed RAS
