|
s13s dont need code readers.. you gotta take out the little panel under the dash on the passanger side... there is a phillips head screw under the dash that holds it in place. then remove the plastic phillips screws on the door side of the panel and on the bottom.. pop the little panel up from the car then you can move the kick panel away from the side.. after you need a 10mm socket to remove the bolt holding the ecu to the car chassis.. next turn the ecu around so you can see the diagnostic screw... you HAVE TO BE GENTLE to the little screw... you need to turn on the key (engine off).. turn the screw all the way to the right... wait 2 seconds then move it completely back to the left.. now watch the little red LED light or look at the check engine light... if it blinks... say 3 times slow and 2 times fast... your code will be 32... slow codes are the first number.. fast blinking is the second number... it will pause for like 2 to 4 seconds then repeat the codes.. to clear them turn the screw to the right and wait 5 seconds... return it to the original position again... you will see a code 55.. 5 long blinks 5 short ones... that means youre good to go.. after that re install all pieces removed and youre done
|