Zilvia.net Forums | Nissan 240SX (Silvia) and Z (Fairlady) Car Forum - View Single Post

240Shwag · 06-06-2012, 05:36 PM

Its been a while since I updated this. I have been working on it and it did not get swept under the rug or forgotton about. I have some more goodies inbound tomorrow. Here are some pictures...

Mocking up front end.

Back to fabrication...

Pretty much where I ended today.

All of the tubing is 1.75" x .095" DOM. If you dudes have any input or anything it would be much appreciated!

Also got more stuff yesterday. Fidanza flywheel, SPL suspension arms, and some other stuff.

I'm going to remove the rear subframe and get to work on that over the weekend. Hopefully get the engine bay primed too. This thread is kinda old, so if it could be moved over to the build subsection that would be cool.

06-06-2012, 05:36 PM	#43
240Shwag Zilvia Member Join Date: Mar 2005 Location: Lakewood, NJ Posts: 258 Trader Rating: (1)	Its been a while since I updated this. I have been working on it and it did not get swept under the rug or forgotton about. I have some more goodies inbound tomorrow. Here are some pictures... Mocking up front end. Back to fabrication... Pretty much where I ended today. All of the tubing is 1.75" x .095" DOM. If you dudes have any input or anything it would be much appreciated! Also got more stuff yesterday. Fidanza flywheel, SPL suspension arms, and some other stuff. I'm going to remove the rear subframe and get to work on that over the weekend. Hopefully get the engine bay primed too. This thread is kinda old, so if it could be moved over to the build subsection that would be cool.