|
I know that this thread is months old, but I would like to point out a few problems with your setup.
I just installed a 350 plus on my sister's Scion TC and the red/white wire should be for output 2. This is to tell the car to pop the trunk, etc. Not to notify the alarm of an open trunk.
2. If the 240sx has a (-) parking light wire, you might have damaged the alarm cpu, etc. by testing it in positive mode.
3. The yellow wire should be tapped into an ignition wire (12v while ignition is on).
Finally, I will have to check again but isn't the white/blue wire another output? If so, it should not be connected to the parking light wire.
Any one of these issues might have damaged the alarm controller. I would correct them, then try testing again. If you still have a problem, you can investigate the circuit board and see if you have any damaged components.
|