Quote:
Originally Posted by Verbal_S13
Now I must ask.... are you fuckin serious? Have you ever done anything aside from pick up a magazine? It's called a pinion angle... you measure it before and after. I use stainless sleeves... so if it did fall apart, it would sit on the sleeve. Quit being a sheep.
|
I am fuckin serious, stainless sleeves dont mean jack fucking shit. I have 4 different hockey puck setups sitting in a fucking bin right now. My guess is none of you have noticed the added wear on the tranny mount, esp if your using a peak performance one. The inside bearings that give the tranny mount the proper squish will warp to hell with pucks. Took 1 trip, with 1/2 torque because the different non correct angle the engine sat because these cheap ass fucking hockey pucks.
So you spent $$$ on sleeves, yet still in the back of your mind, you have some ghetto rigged bolt going through a set of pucks, that doesnt even fit flush with the front crossmember/engine, thus requiring washers, or just being plain ghetto.
These were plain awfull, and the vibration was horrid. JGS or filling your OE mounts are 100x better. Fill your mounts.