Here are some shots of the downpipe. I figured I would build it with check engine light eliminators in case I wanted to mess with them down the road.
Some shots of the turbo elbow installed with the downpipe. As you can see I capped off the wg and turbo cartridge because this is my daily driver and I have to keep it on the road as I build the kit. With the wastegate so close to the downpipe, it makes doing a dumptube or recirc simple and out of the way.
After the elbow and downpipe were done I started on the crossover pipe. I wanted to make sure it flowed enough to make some power so I used 2.25" stainless tubing. Paying close attention to available room and performance, we reworked the wiring harness to give extra room.
This made it possible for a crossover pipe with no extra bends or kinks and it won't melt your wire harness.
