So Today my main mission was to align door ,C pillar , and trunk hood. So first off I needed to cut C pillar to fit .After brain storming and using my brain a little . I went over to my old QP , took a rool of 3m masking tape and taped over the C pillar section I cut off. I then took my trusted sharpy and traced curves and lines . Then I pulled tape off , placed it over a piece of card board and cut the C pillar tracing. I then took Template and taped it directly over Exact section on Donor QP.
By
nismolvr at 2011-06-06
By
nismolvr at 2011-06-06
By
nismolvr at 2011-06-06
Self explanatory
By
nismolvr at 2011-06-06
Perfect cut
By
nismolvr at 2011-06-06