Quote:
Originally Posted by jr_ss
If they were meant to go to 105, I don't think they would stretch like it did Steve. I have never heard of going over 80lbs with ARP's in the SR application.
|
You are not supposed to torque over 80 ft lbs.
75-80 MAX is what everyone uses who builds SRs for any length of time.
There was a write up on it on Freshalloy in 2002...
Now unless ARP has changed the model they sell for th SR...This could be possible.
I remember about 4 years ago they were still using the LS Acura Integra motor studs which on the SR only needed to be torqued to 75 lbs max because they did not SEAT all the way into the deck of the block/ or thread all the way down 100% into the holes in the deck of the blck. So they handled slightly different tolerances due to this