Thanks SolTNtuz...
Ok got the trans off, clutch plate and now the dreaded flywheel bolts... I have an impact wrench, but low budge. Not a lot of psi in this thing... 20gal compressor. So, I will brute force breaker bar dance with this mother.
Oh, can someone help me with naming these plugs on the side of the trans. As you can see, one was never even hooked up, dead center...wonder what what that one is/was. Anyway, if you could, help me name the stuff (sensors?) on the side of this thing. Maybe, "from left to right"? I know I could look in the fsm, but thought this might be quicker.
I am hoping to get this on the stand today sometime. I will stop by here if I get stumped. Oh, also I measured the engine stand attachments on the stand and the bolts that I want to use on the rear of the engine, trying to use the best possible locations to use at centering it, and of course each bolt has a different length, and then adding that amount for the length of the bolt to use. That should be good ya? Any recommendations before I set out? Thanks.