Supertech valvetrain components are good quality. Ask Mark over at Mazworx, I believe they are sponsored by Supertech, but anyways, it's good stuff.
I would suggest the JWT S3 cams for the GT2871r .64ar, HKS cams are good, but I have personal experience with that particular setup.
Intake manifold is a good idea too, as well as 740cc injectors as already suggested.
For engine management, I would just get an enthalpy tune if I were you. Being able to check codes is nice, plus with a setup like yours, Scott is likely to have a spot-on tune, you'll end up spending less money than buying a PFC, then paying to have it tuned too.
Lastly, you might want to go ahead and use ARP headstuds when you change out the headgasket.
Quote:
Originally Posted by eek
About to buy some cams for my setup. Any suggestions? I've been following this thread, and noticed alot of people run BC cams, but I also hear alot of bad stuff about BC too.
I'm leaning towards the HKS step 2 264 or the Tomei 260 Procams. Also what are your thoughts about Supertech valvesprings + retainers? Last, Greddy intake manifold worth buying or should I just keep stock? Thanks.
Current Setup:
S14 sr20det (kouki)
GT2871 .64
Tomei Expreme manifold
Tomei Expreme Elbow
3" Downpipe & test pipe
Greddy ti race exhaust
Nismo 555cc injectors
Warlbro 255 pump
Z32 Maf w/ hks intake
Blitz SBC-id III
Greddy FMIC & Greddy rs bov
Stock ecu w/ safc2 (ordering a PFC soon)
Apexi headgasket (on order)
|