|
95KA-Turbo,
I finally did some measuring.
I measured the entire length of the tie rod, minus the ball joint part and the part that threads into the rack itself, so these are just the lengths of the "thin" rod part.
Tein Z33 - 7-3/16" from the ball joint to the end of the rod.
Tein S-chassis - 9-1/8" from the ball joint to the end of the rod.
So you see, it's almost exactly 2 inches in difference between those two.
I believe the only difference you'll notice between the Z33 and Z32 tie rods, would be that the Tein Z33 tie rods come with the Tein steering rack spacers, which are 6mm in thickness, so if you put those on, the Tein Z33 tie rods will be 6mm longer, in a sense, than the Z32 tie rods w/ just the locking plates on them.
I ordered the PBM steering rack spacers, which are 7mm instead of 6mm, so that should give me a tiny bit more angle before going with modified knuckles, and they should be here tomorrow.
I will see where my tie rod ends place my toe tomorrow night.
|